Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

P0062-HO2S-Heater-Control-Circuit
#1

HO2S Heater Control Circuit

Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

Cause:
Faulty Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3
Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 harness is open shorted
Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 circuit poor electrical connection
Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 circuit fuse
Faulty Engine Control Module (ECM)

Symptoms:
Check engine light
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)